Condenser Heat Rejection, Energy Use, and Water Use. Superheating the steam to high temperatures:- The compressor rack also allows superheat heat reclaim and heat rejection to a conditioned zone. Condenser capacity formula for hermetic comp. the first figure, you can see that the heat rejection at the evaporator and condenser change from air to water as you move from split system to water cooled chilled water system. Large chillers often have a separate heat rejection system linked by pipework, enabling the chiller to be located in a plant room. Water-cooled condensers involve a heat rejection loop where condenser heat is dissipated to the environment via water. A heat rejection system can take several forms. 2. The most common type of water-cooled condensers in geothermal power plants are direct-contact and surface types. Condenser capacity formula for open drive comp. superheated refrigerant vapor is condensed, rejecting its sensible and latent heat in the condenser. 1.25 x comp capacity. Heat of Compression + Evaporating Load = Total Heat of Rejection 6500 watts x 3.4 = 22,100 Btu Heat of Compression = 22,100 Btu Evaporating Load = 40,200Btu Total Heat of Rejection = 62,300 Btu Total Heat of Rejection (THR) is the heat absorbed at the evaporator plus the heat picked up in the suction line plus the heat added to the refrigerant in 10â¢f â¦ The high pressure, high temperature refrigerant vapour leaving the compressor inters into the condenser where the latent heat of vaporization of refrigerant is removed in the The most efficient is the evaporative cooling tower which uses the cooling effect of evaporating water to â¦ The compressor rack can reject heat to an air-, water-, or evaporative-cooled condenser. The capacity of an air-cooled condenser are based on Total Heat of Rejection (THR) of the refrigeration system. An Analysis of Rejected Heat from the Condenser of conjugal Refrigerator 269 would be able to dissipate its latent heat to the atmosphere through condenser. The overall effect of lowering the condenser pressure is an increase in the thermal efficiency of the cycle. This change in heat rejection from air to water greatly improves the efficiency because the heat transfer is much better with water due to its increased heat capacity. The condenser type determines the heat rejection temperature used for the compressor rack COP calculation. The formula for calculating the heat load from common injected resins is as follows: Q = Lbs per hour x Specific Heat x Delta-T ... condenser plus the hydraulic heat load if cooled by the chiller. Condenser heat rejection is normally larger than the evap capacity by ï¸what percent for hermetic comp. Otherwise the tower will be Lowering the condenser Pressure:- Lowering the operating pressure of the condenser lowers the temperature at which heat is rejected. Capacity for air-cooled condensers are based on Total Heat of Rejection (THR) at the condenser. 10 Analysis of condensers The total heat rejected in the condenser, QC is given by: m is the mass flow rate of refrigerant h2, h4 are the inlet and exit enthalpies of refrigerant mext is the mass flow rate of the external fluid Cp, ext is an average specific heat of the external fluid Text,o and T ext,i are the inlet and exit temperatures of the external fluid 30%. 1.3 x comp cap. Subsequently, the liquid refrigerant flows from the condenser through the expansion valve, where pressure and temperature are reduced to those in the evaporator, thus completing the 1 Btu = amount of heat required to raise (or lower temperature of one pound of water 1oF 1 ton refrigeration = 12,000 Btu/h = 200 Btu/min 1 watt = 3.412 Btu/h 1 horsepower = 2545 Btu/h 1 lb = 7000 grains 1 ft (head) = 0.433 psi 1 square foot EDR (equivalent direct